How to Cut Formica With a Utility Knife

Hunker may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.
A utility knife can be used to make scoring cuts on Formica.

Formica brand plastic laminate is most commonly used to cover countertops, cabinet doors and drawer fronts. Formica is a leading brand whose name has been synonymous with laminate for decades. Since all plastic laminates are essentially the same, cutting Formica with a utility knife is identical to cutting most laminates. This method works well for one or two shorter cuts, but is too time consuming and inconsistent to use for larger projects.

Advertisement

Step 1

Measure your installation face side to side and front to back with a tape measure. Add one-half inch to each dimension to calculate the size of laminate needed for a standard installation.

Video of the Day

Step 2

Lay your laminate out on a stable work surface, with its backing face up for marking. Use a drywall square to mark off the size piece required. Work from a corner in to minimize the number of cuts required.

Advertisement

Step 3

Set the square crosswise on the panel to cut the Formica across the width of the 4-by-8-foot sheet first. Install a fresh blade in the utility knife if it has been used for more than one or two cuts. Align the square dead on the cut line.

Step 4

Stand at one end of the workspace so that the square is horizontal to you, to keep from drawing the knife toward yourself. Grasp the knife firmly in your dominant hand. Hold the square firmly in place with your other hand and draw the knife along its edge to score the back of the laminate. Repeat this action two or three times until the mark is fairly deep.

Advertisement

Step 5

Move the laminate so that the score mark is aligned with one edge of your work table. Lift up on the end opposite the piece you will be using. Snap it downward to break the laminate along the score line. Set the unused portion of the laminate sheet aside.

Step 6

Turn the laminate one-quarter turn and align the square along the next cut line. Draw the knife across the surface, applying firm pressure, two or three times. Shift the score line to the table edge and break the laminate again. Repeat for any additional cuts.

Video of the Day

Advertisement

Advertisement

Report an Issue

screenshot of the current page

Screenshot loading...