How to Disable a Dryer's Buzzer

Hunker may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

How to Disable a Dryer's Buzzer. The loud buzz that signals the end of the dryer's cycle is often an irritating and unnecessary disturbance. Luckily, disconnecting the buzzer on a dryer is a relatively simple and safe process. If you are tired of hearing the loud alarm of your dryer's buzzer, follow these steps to disconnect the buzzer.

Step 1

Turn off and unplug the dryer. Since you need to remove the front panels and expose the electrical wiring of the dryer's buzzer you should turn the dryer off and then unplug the machine to avoid shocks. Once the dryer has been unplugged, turn its dial to the "on" setting to make sure the dryer is completely powered down.

Advertisement

Video of the Day

Step 2

Locate the buzzer. The best way to locate the dryer's buzzer is to check the machine's schematic or manual. The buzzer is usually located behind the front panel of the machine. In some cases the buzzer is located behind the dryer's back panel. Dryer buzzers are generally small black boxes that are wired to the timing device.

Step 3

Pull the buzzer's wires. The most simple way to deal with a buzzer is to pull the wires that run into the buzzer. The wires should pull free with a firm but careful tug. Once you've disconnected the wires from the buzzer simply run a good amount of electrical tape over the ends so that no live wires are exposed. If you want to get the wires out of the way, tape the wrapped wires to the top or side of the dryer panels.

Advertisement

Step 4

Test the machine. Once you've yanked and taped the buzzer's wires, plug the dryer back in and turn the machine on to test the buzzer. If the machine still buzzes at the end of the cycle then you removed the wrong wires. However, chances are that the machine will finish its drying with a quiet whimper instead of a loud buzz.

Advertisement

Advertisement

Video of the Day

Report an Issue

screenshot of the current page

Screenshot loading...