How to Build a Hand Railing on Exterior Concrete Steps

Exterior concrete steps are durable and last for many years. Metal hand railings will last as long as the steps and not need replacing. A metal hand railing involves setting the vertical posts into the concrete steps to anchor them securely in place. Hand railings help persons balance themselves when going up or down steps with packages and help the elderly maintain their balance.

...
Handrails provide stability and safety on concrete steps.

Step 1

Place the handrail loosely assembled with the vertical posts and top rail on the steps.

Step 2

Draw a circle around the bottom of each vertical post on the concrete with a marker.

Step 3

Remove the handrail and set it aside.

Step 4

Place a metal flange over one of the marks on the concrete. Center the flange so that the post hole marking is in the center of the flange. Place a marker in each of the four screw holes in the flange to mark the concrete. Repeat this step for each flange.

Step 5

Place a ½-inch masonry bit in a drill. Place the drill on one of the screw hole marks on the concrete. Hold the drill at a 45-degree angle to the concrete and squeeze the trigger to drill straight down into the concrete. Repeat this process for each screw hole.

Step 6

Place a flange on the marks for each vertical post on the concrete steps.

Step 7

Drill a 1/4-inch concrete screw into each of the four screw holes on each flange.

Step 8

Set a vertical post in each flange and hold a level on the side to ensure it is level horizontally and vertically.

Step 9

Place an Allen wrench into the flange and turn it clockwise to tighten the post into the flange. Repeat this process for each vertical post.

Step 10

Slide a swivel socket on each vertical post near the top and slightly tighten them with an Allen wrench to hold them in place.

Step 11

Slide the top handrail through the swivel sockets and center it on the vertical posts.

Step 12

Tighten the handrail to the vertical posts with an Allen wrench. Tighten the swivel sockets onto the vertical posts entirely by turning the Allen wrench clockwise.