The Intex pool vacuum system is a little different than most other vacuum methods that you would use on the pool floor. The type of system that Intex provides does not hook to the pool pump, but works independently. The system is unique in the way it works and requires no adjustments to the pool pump, but does require water pressure.

...
Keep your pool clean with a vacuum system.

Step 1

Hook up the garden hose to the house spigot. The hose will need to be long enough to reach from the house to the farthest part of the pool with a little slack so you don't need to stretch or strain the hose.

Step 2

Put the two pieces of the telescoping shaft together by inserting one end into the other and twisting counterclockwise to lock in place.

Step 3

Align the shaft with the vacuum head where you see the spring. Squeeze the plastic tips of the spring together until the shaft slips into the vacuum head.

Step 4

Attach the debris bag to one side of the vacuum head. Use the ties on the bag to tie the bag to the vacuum head.

Step 5

Attach the garden hose adapter nozzle to the opposite side of the vacuum head. Clip the hose to the telescoping shaft and wind the hose on the adapter nozzle. Note: There is a flat washer that comes with the adapter that must be placed inside of the garden hose coupling.

Step 6

Turn on the water so that there is water pressure. The first time that you use the vacuum system, you will have to adjust the water output so that you are getting the correct water pressure to allow the vacuum to suck up the debris on the pool floor.

Step 7

Place the vacuum head on the pool floor and slowly glide it around the pool to clean the debris.