×
Back Button

How to Build a Concrete Sump Pit

Tom Raley

A sump pit is a hole located in an area where unwanted water gathers. The purpose of the pit is to collect the water so it can be easily removed either by hand or by way of a sump pump. Some pits are nothing more than a 5 gallon bucket wedged into a crudely dug hole.

Tip

By setting the frame on top of the wet concrete, you eliminate any seam when you add the remaining concrete. This will help prevent seepage.

Warning

If you increase the depth of the hole, also increase the width. This will allow you adequate room to work on the base of the pit.

A sump pit is a hole located in an area where unwanted water gathers. The purpose of the pit is to collect the water so it can be easily removed either by hand or by way of a sump pump. Some pits are nothing more than a 5 gallon bucket wedged into a crudely dug hole. For a more efficient and reliable system, you will want to build something a bit more sturdy.

  1. Dig a hole a minimum of 24 inches wide and 27 inches deep. The hole can be larger and deeper, but this size will give you a finished pit of 18 inches wide by 24 inches deep. This will work very well with almost any brand or style of sump pump you may install. The sides of the hole need to be free of any obstructions such as stones or tree roots. You will also want a smooth surface so you get a uniform concrete thickness throughout the pit.

  2. Build a frame to fit inside the hole so when it is inserted there will be 3 inches of open space on all sides. Build the frame 3 inches shorter than the depth of the pit. Example: If your hole is 27 inches deep, make the frame 24 inches in height. Build the frame sturdy; if it should fail, the clean-up would be messy as well as time consuming.

  3. Use the wheelbarrow to mix the cement. With the frame out of the pit, pour in enough cement to cover the base of the pit with 3 inches of concrete. Allow this to sit for a short time, no more than 30 minutes, then carefully put the wooden frame into the pit. Keep the frame centered and level as you pour the remaining concrete around the outer edges. Bring the concrete up level with the existing floor. You will then need to pack the concrete down to eliminate any air pockets and smooth it out to a nice finish.

  4. Allow the concrete to set for a minimum of 24 hours before removing the frame. Once the frame is removed, the concrete should be allowed to sit undisturbed for another 48 to 72 hours. After that time, the pit is ready for use.