How to Wire a 2-Wire Thermostat to a 4-Wire System

Hunker may earn compensation through affiliate links in this story.

Things You'll Need

  • Phillips jeweler's screwdriver

  • Replacement two-wire thermostat


Verify that the electricity is turned off by plugging a table lamp into a wall outlet and turning it on to see if it works.

Tape the fuse box closed with strips of duct tape to prevent usage while wiring the thermostat.

If you have any concerns about wiring, wear electrician’s rubber-insulated gloves to protect your hands against electric shock.

A thermostat is designed to control the temperature of a heating or cooling unit in the home. Replacing an outdated four-wire thermostat with a newer model that uses two wires is not complicated, once you purchase the thermostat from a home-and-garden shop or hardware store. The procedure to install the new thermostat is straightforward and does not require the assistance of a certified electrician. A few tools found around the house are all that's needed.


Step 1

Remove the fuse or trip the circuit breaker in the fuse box that supplies power to the thermostat and the unit that it controls. Details as to which fuse/circuit breaker affects which electric line is typically noted on the inside of the fuse box or beneath the fuse/circuit breaker.

Video of the Day

Step 2

Remove the cover from the thermostat. Typically, this involves pulling the cover off, although in some cases you might first need to wiggle one side loose and then the other.

Step 3

Remove the screws from around the thermostat with the Phillips jeweler's screwdriver. Pull the thermostat out from the wall.


Step 4

Aim a flashlight at the terminal block inside the wall to determine which screws are connected to the red and white wires attached to the thermostat. Loosen the screws on the terminal block with the Phillips jeweler's screwdriver. Unwind the four wires attached to the thermostat from around the screws. Remove the thermostat and dispose of it properly.

Step 5

Wind the exposed end of the red wire attached to the replacement thermostat around the screw that formerly held the red wire from the old thermostat. Wind the exposed end of the white wire attached to the replacement thermostat around the screw that formerly held the white wire from the old thermostat. Tighten these two screws as well as the other two screws on the terminal block.


Step 6

Place the replacement thermostat against the wall and screw it on using the Phillips jeweler's screwdriver. Place the cover over the replacement thermostat. Restore electric power to the thermostat and the unit it controls.


references & resources

Marshal M. Rosenthal

Marshal M. Rosenthal is a technology maven with more than 15 years of editorial experience. A graduate of Brooks Institute of Photography with a Bachelor of Arts in photographic arts, his editorial work has appeared both domestically as well as internationally in publications such as "Home Theater," "Electronic House," "eGear," "Computer and Video Games" and "Digitrends."