Whether you've already installed peel and stick tiles on your floor or you're simply considering them, note that the tile can cause problems in the long run if it's not installed properly at the beginning. Also called self-adhesive vinyl tiles, peel and stick tiles are typically less expensive than traditional vinyl, costing about a dollar per square foot.
One of the most common problems with peel and stick tile is bubbling. Bubbling occurs after the flooring has been applied and typically refers to pockets of air that sometimes occur between tiles and the sub-floor. In most cases, bubbling is caused by poor initial adhesion due to a wide variety of factors, including an uneven sub-floor surface or excess moisture on the sub-floor surface.
If you've installed peel and stick tiles and they've shifted, leaving gaps between the tiles, you probably left a space or gap somewhere when you installed the tile originally. Unlike laminate, self-adhesive vinyl tile is installed flush against each wall and spans the entire room or space. No excess gaps are left around the wall. If you left even the smallest gap between your wall and your tile due to a difficult cut or other factor, over time your vinyl tiles will shift, leaving gaps between the tiles.
Depending on the age and composition of your tiles, rolling edges can become a problem as self-adhesive vinyl tiles get older. The adhesive ages and releases at the corners. In some cases, adhesive may not stick, causing corners to roll from first installation, but this is typically only a problem with older or very poor quality brands.
Sienna Condy began writing professionally in 2001 while attending the University of Cincinnati, and she's been at it ever since. Since graduating, she's written everything from marketing materials to articles on removing stains. Today, she enjoys writing about weddings, legal issues, science, health and parenting.