How to Build Steps on a Steep Hill Side

Hunker may earn compensation through affiliate links in this story.

Things You'll Need

  • Tape measure

  • Stakes

  • Mallet

  • Shovel

  • String

  • Wood 6-by-6-inch beams

  • Saw

  • Drill

  • Rebar

  • Galvanized spikes, 12 inches long

  • Gravel

  • Sand

  • Tamp

  • Bricks

  • Broom

Traversing a steep hill can be a difficult proposition, particularly for those who have disabilities which lessen their ability to walk around on their own. Building a set of steps converts a steeper hill from impassible into a reasonable walkway. Not only can you build the stairs out of wood beams and red brick without the help of a professional, but it also creates an eye-pleasing set of stairs that will dazzle visitors.

Step 1

Measure the rise, the vertical distance of the slope, and the run, the horizontal distance of the slope, in inches.

Step 2

Divide the rise of the slope by 6 inches, rounding up, to determine the number of steps you will need.

Step 3

Put stakes in the ground at the bottom of the slope and the top of the slope to mark out the footprint of the steps, then tie string around the perimeter of the four stakes.

Step 4

Divide the run by the number of steps to determine the length of each step.

Step 5

Dig a trench for the runners of the bottom step with an angular-U shape. Runners are made from wood 6-by-6 boards, so the trenches must be 6 inches wide, with the bottom trench as wide as the desired staircase width and the arms 6 inches longer than the determined step length.

Step 6

Cut wood 6-by-6 boards as wide as your stairs so there is one more piece cut than there are steps in the staircase.

Step 7

Cut two 6-by-6s as long as the step length for every step except the top step, and two 6-by-6s as long as the step length minus 6 inches for the top step.

Step 8

Drill through both ends of one 6-by-6 as wide as the staircase and two 6-by-6s as long as the stair length, 3 inches in from each end and centered across the 6-inch width.

Step 9

Place the drilled beams into the trench.

Step 10

Drive a piece of rebar through both holes in the beams to secure them.

Step 11

Dig out the interior of the step, keeping a straight edge from the end of one side beam to the other.

Step 12

Dig a trench for the side beams of the next highest step.

Step 13

Place a side beam in each trench, and a cross beam at the end of the beams atop the frame for the bottom step, and secure in place with a 12-inch spike through the beams and into the side beams of the step below.

Step 14

Dig out the interior of the step, keeping a straight line across the back.

Step 15

Continue adding steps until you have framed the top step. As the top step does not need to extend under the step above it, its side bars are not cut with the extra 6 inches.

Step 16

Pour a mix of gravel and sand into each step, tamping every few inches poured. Continue adding until the mixture is high enough in each step that a brick placed atop it is level with the top of the frame for that step.

Step 17

Lay bricks inside the frames, with a 1/8-inch gap between bricks.

Step 18

Pour masonry sand over the top of the bricks and brush over them with the broom until the sand settles between the bricks.


Robert Preston

Robert Preston is a professional writer who majored in journalism at The College of New Jersey. In addition to work for various websites, Preston has done public relations with Major League Lacrosse's New Jersey Pride organization, where he served as the team's beat reporter.