Kirby vacuum cleaners are well engineered cleaning machines, but after prolonged use, some components will start to wear down. For instance, as the belt on your Kirby deteriorates and stretches out, it will cause the brush mechanism to stop performing at its best. Fortunately, the belt is designed for easy replacement without tools.
Make sure the vacuum cleaner is unplugged. On newer models, disengage the TechDrive feature by placing the pedal in the "Neutral" position. Press the height adjustment pedal to its lowest position in order to raise the power nozzle to its highest level.
Raise the light hood and open the L-shaped handle of the belt lifter. Use the handle to rotate the lifter all the way left (counterclockwise), aligning the red arrows.
Unlock the power nozzle by rotating the accessory lock to the left (counterclockwise). The entire power nozzle unit will tip forward and detach from the rest of the vacuum cleaner.
Release the belt by using the L-shaped handle. Rotate the handle to the right (clockwise) until the green arrows are aligned.
Turn the power nozzle over and unlock the rug plate by unhooking the two rotating latches at the rear. Take note of which height (1, 2 or 3) the brush roll setting is on. Remove the rug plate and then lift out the brush roll and belt.
Remove and discard the old belt. Replace it with a new belt and place it back into the power nozzle on the same height setting as when it was removed. Center the new belt on the roller brush. Replace the rug plate and secure in place with the two rotating latches.
Rotate the L-shaped handle of the belt lifter to the left (counterclockwise) to align the red arrows. This should stretch the new belt up in preparation for being reattached to the vacuum. Re-attach the power nozzle to the vacuum and lock it in place by turning the accessory lock to the right. Now use the handle to rotate the belt lifter right (clockwise) until the green arrows are once again aligned.
It may take a few tries to get these steps right. Check to see if the roller is functioning when you turn the vacuum on. If the roller is not moving, remove the power nozzle and repeat the steps. Check to make sure that the belt is stretched on the belt lifter before placing it back on the vacuum. If it's not stretched, it will not properly connect with the motor shaft.
Based in Ohio, Deborah Waltenburg has been writing online since 2004, focusing on personal finance, personal and commercial insurance, travel and tourism, home improvement and gardening. Her work has appeared on numerous blogs, industry websites and media websites, including "USA Today."